|
|
发表于 2008-11-4 23:35:16
|
显示全部楼层
老大我刚才去看了，这玩意儿默认是光盘启动的。可以安装到U盘上。
Install Puppy to usb
Within Puppy using SYSLINUX
This has been confirmed to work on:
Sandisk cruzer micro 4GB (with U3 removed); older PNY 1GB; if anything else works, or just to contact me, email me at [email protected]
I installed puppy to USB, right? Well... it didn't work at first with superfloppy mode. Before you begin, burn a puppy linux cd. I used Burning Thunder Pup. Boot it.
1、刻录一张启动盘。启动。
First, make sure that there ARE partitions. If you tried SuperFloppy mode, add a partition! I used FAT32, W95 FAT32 in fdisk. A Win Format should also work, but no NTFS!
2、确定用fat32分区，ntfs不行滴。
Second , in the installer (menu,setup,puppy universal installer), pick usb flash drive , select your drive.
3、在 菜单-安装-puppy安装里，选择usb设备 的分区
Then, hit the installl button ON THE TOP, NO OPTIONS ON THIS SCREEN. Go through the sanity check. choose mbrfat.bin then syslinux.
4、然后点安装按钮。
Go through The Questions, Answer them on your own. when done, shutdown puppy. remove the cd. copy (or move) your pup-save.*fs file (where applicable). Enjoy puppy.
5、接下来回答几个问题，关掉puppy,移除光盘或者把你的配置文件复制过去，都是可选的。
I recommend Burning Thunder Pup.
Without Puppy using SYSLINUX
6、我推荐使用Thunder Pup 发行版，下载在http://www.filefactory.com/dlf/f ... ing_Thunder_Pup_iso
因为这玩意儿不用syslinux引导。
（二斤注：意思就是说直接用内核启动起来会好一些，不用syslinux引导程序，linux本身其实不需要引导程序，内核在可启动分区的最前面就成。）
http://aronzak.wordpress.com/2008/10/07/usb-linux-howto-puppy-41/ |
|
狗仔卡
恢复卡
发表于 2008-11-5 09:13:22